Brad's Car Manuals: A 3rd party mirror of CHARM + LEMON car manuals
Home >> Acura >> 1999 >> Integra GS-R, 4D Sedan >> Repair and Diagnosis >> Engine Performance >> Engine Controls - On-Vehicle Adjustments >> Ignition Timing >> Checking Ignition Timing >> Except Integra & 2.3CL

Except Integra & 2.3CL

Download the full database via torrent (~1.1 TB)  |  Download Brad's custom LEMON patches
  1. Start engine and run at 3000 RPM, with no loads and transmission in Park or Neutral, until radiator fan comes on. Allow engine to idle. Locate 2-pin service check connector (under glove box). Install Service Check Connector Tool (07PAZ-0010100) into service check connector. See Fig 1 .
  2. On 3.0CL, connect inductive timing light to No. 1 spark plug wire. On 3.2TL, connect timing light to ignition coil No. 1 wire. On 3.5RL, remove strut brace and engine cover. Connect inductive timing light to No. 1 spark plug wire.
  3. On all models, ensure idle speed is within specification. See IDLE SPEED under IDLE SPEED & MIXTURE. Red mark on crankshaft pulley should align with pointer on front of engine. See Fig 2 . If timing is not as specified (Red mark and pointer are not aligned), replace ECM/PCM. Timing is not adjustable.
Fig 1: Installing Service Check Connector Tool
G96C01345Courtesy of AMERICAN HONDA MOTOR CO., INC.
Fig 2: Identifying Ignition Timing Marks (V6 Shown; Others Are Similar)
G93A78063Courtesy of AMERICAN HONDA MOTOR CO., INC.
scientia non olet · About Brad's Car Manuals