Selector Control Shaft Bearing Replacement: Overview

Special Tools Required 

• Bearing Remover Shaft Set, 15 mm 07936-KC10500
• Slide Hammer 07936-371020A
• Driver Handle, 15 x 135L 07749-0010000
• Bearing Driver Attachment, 32 x 35 mm 07746-0010100

1. Remove the selector control shaft bearing from the torque converter housing using the slide hammer and the 15 mm bearing remover shaft set.
   Fig 1: Removing Selector Control Shaft Bearing From Torque Converter Housing

   Courtesy of AMERICAN HONDA MOTOR CO., INC.
2. Install a new bearing until it bottoms out in the torque converter housing using the 15 x 135L driver handle and the 32 x 35 mm bearing driver attachment.
   Fig 2: Installing Bearing Until It Bottoms Out In Torque Converter Housing

   Courtesy of AMERICAN HONDA MOTOR CO., INC.