3.2L - Fuel Injection Ignition, Engine Code(S): BKH

• 24 - Fuel injection system
  • Simos fuel injection system, servicing
    • Safety precautions
    • Rules of cleanliness for performing work on fuel injection system
    • Procedure that must be performed before opening the high-pressure fuel injection system - Pay close attention!
    • Technical data
    • Component locations, overview
      • Engine compartment, right
      • Engine compartment, left
      • Component location SIMOS Control Module J361
      • Location Throttle Position (TP) Sensor G79/Accelerator Pedal Position Sensor 2 G185
      • Component location Brake Light Switch F/Brake Pedal Switch F47 , Clutch Pedal Starter Interlock Switch F194 and Clutch Position Sensor G476
      • Right holder for connectors on bulkhead
      • Left holder for connectors on bulkhead
      • Oxygen sensors location, cylinder bank 1 (right)
      • Oxygen sensors location, cylinder bank 2 (left)
      • Electrical connectors on right rear of engine
      • Electrical connectors on left rear of engine
      • Hall sensor and valve for camshaft adjustment, bank 1
      • Hall sensor and valve for camshaft adjustment, bank 2
      • Component location front on engine
      • Component location on rear of intake manifold
      • Location on high pressure pump - older version
      • Component location Low Fuel Pressure Sensor G410 - new version
      • Leak Detection Pump (LDP) N144 or Right Electro-Hydraulic Engine Mount Solenoid Valve N145 installation location
      • Component location under intake manifold, cylinder bank 1 (right)
      • Component location under intake manifold, cylinder bank 2 (left)
      • Location Intake Air Switch-Over valve N335
      • Location Engine Speed (RPM) Sensor G28
    • Air filter, component overview
    • Air filter element, removing and installing
    • Intake manifold upper-part, component overview
      • Notes
      • Installed location of tooth segments for variable intake manifold
    • Intake manifold upper-part, removing and installing
      • Removing
      • Installing
      • Torque specifications
    • Intake manifold lower-part, component overview
    • Intake manifold lower-part with fuel rail, removing and installing
      • Notes
      • Removing
      • Installing
      • Torque specifications
    • Fuel injectors, removing and installing
      • Notes
      • Removing
      • Installing
    • Fuel pressure and residual pressure before high pressure pump, checking
      • Notes
      • Torque specifications
    • High pressure pump, removing and installing
      • Notes
      • Removing
      • Installing
      • Torque specifications
    • Fuel system, bleeding
    • Wiring and components, checking with Test box V.A.G 1598/42
    • Engine Control Module (ECM), removing and installing
      • Notes
      • Removing
      • Installing
    • Oxygen sensor before catalytic converter, bank 1 (right side), removing and installing
      • Notes
      • Removing
      • Installing
      • Torque specifications
    • Oxygen sensor before catalytic converter, bank 2 (left side), removing and installing
      • Notes
      • Removing
      • Installing
      • Torque specifications
    • Oxygen sensor behind catalytic converter, bank 1 (right side), removing and installing
      • Notes
      • Removing
      • Installing
      • Torque specifications
    • Oxygen sensor behind catalytic converter, bank 2 (left side), removing and installing
      • Notes
      • Removing
      • Installing
      • Torque specifications
• 28 - Ignition system
  • General information and safety measures
    • Ignition system, general information
    • Safety precautions
  • Ignition, servicing
    • Technical data
    • Ignition coils, removing and installing
      • Notes
      • Removing
      • Installing