Using GT1:
- Park the vehicle where it does not obstruct (programming may take up to 4 hours).
- All control modules must be installed and functional.
- Perform a fault memory deletion with "Quick Clearing ".
- Readout and print Individualization settings with the CIP Program (Vehicle & Key Memory will be deleted during programming) .
- Read out (and print if applicable ) Instrument Cluster/Control Display (mileage, Condition Based Service data, radio station settings, etc.).
- Engine must be off and cooled down (trans. oil temp. must be < 85°C).
- Transmission in P or N position, vehicle must not move.
- Coding/Programming all control modules (with the ignition on - KL15) , except the CAS.
- Coding/Programming the CAS module with the ignition switched "off" and key removed.
- Switch off all electrical consumers.
- Do not move seats, trunk lid, steering wheel, locks, windows, etc.WARNING: Wipers can move unexpectedly (make sure path is clear and moisten glass).
- Current version of Navigation CD must be available when programming with CIP.
- Print as you go for all CIP procedures (Measures Plan, Program abort, multiple attempts).
- Initializing control modules (indicated on screen).
- Re-establishing customer VKM settings overwritten during Coding/Program (reverts to factory settings).