Fuel Injector(s)

Download the full database via torrent (~1.1 TB)

Disconnect fuel injector harness connector. Measure resistance across injector terminals at each injector. Resistance should be as specified. See INJECTOR RESISTANCE SPECIFICATIONS table.

INJECTOR RESISTANCE SPECIFICATIONS (At 140°F (60°C))

Application	Ohms
4.3L (VIN Z)	1.2
5.0L (VIN E)	1.2
5.7L (VIN 7)	1.2

NOTE: If injectors are dirty, they should be cleaned using approved injector cleaning procedure before performing PFI INJECTOR BALANCE TEST.