Fuel Injector(s)

Download the full database via torrent (~1.1 TB)

Disconnect fuel injector harness connector. Measure resistance across injector terminals at each injector. Resistance should be as specified. See INJECTOR RESISTANCE SPECIFICATIONS table.

INJECTOR RESISTANCE SPECIFICATIONS ⁽¹⁾

Application

Ohms

4.3L & 5.7L

11.8-12.6

⁽¹⁾	Injector resistance specification is at 140°F (60°C).

NOTE: If injectors are dirty, they should be cleaned using approved injector cleaning procedure before performing INJECTOR BALANCE TEST.