Electronic Brake Control Module Programming and Setup

Download the full database via torrent (~1.1 TB) | Download Brad's custom LEMON patches

Electronic Brake Control Module Programming and Setup

EBCM Replacement

If the electronic brake control module (EBCM) is replaced, the following procedures must be performed:

* EBCM Reprogramming-Refer to Service Programming System (SPS) (Programming and Relearning) .
* Recalibrate the brake pedal position (BPP) sensor (Without JL7). Refer to Brake Pedal Position Sensor Replacement (Brake Pedal Position Sensor Replacement) .
* Recalibrate the steering angle position sensor (Without JL7). Refer to Steering Angle Sensor Centering (Procedures) .
* Recalibrate the yaw rate sensor (Without JL7).