Replace and Program Frontview Camera Module or Reprogram Frontview Camera Module (without UGN)

To program a replacement or an existing Front View Camera Module, perform the following procedure:

1. Access the Service Programming System (SPS) and follow the on-screen instructions.
2. On the SPS Supported Controllers screen, select K109 Frontview Camera Module - Programming and follow the on-screen instructions.
3. At the end of programming, choose the "Clear DTCs" function on the SPS screen.
4. Following K109 Frontview Camera Module replacement and reprogramming, the module must be calibrated. Refer to Front View Camera Module Calibration .