Replace and Program Frontview Camera Module or Reprogram Frontview Camera Module (without UGN)

To program a replacement or an existing Front View Camera Module, perform the following procedure:

1. Access the Service Programming System (SPS) and follow the on-screen instructions.
2. On the SPS Supported Controllers screen, select B174W Frontview Camera - Windshield - Programming and follow the on-screen instructions.
3. On the SPS Supported Controllers screen, select B174W Frontview Camera - Windshield - Setup (if this option is available)  and follow the on-screen instructions.
4. At the end of programming, choose the "Clear DTCs" function on the SPS screen.
5. Following B174W Frontview Camera - Windshield replacement and reprogramming, the module must be calibrated. Refer to Front View Camera Module Learn .