Crankshaft Position Sensor: Service and Repair

Download the full database via torrent (~1.1 TB) | Download Brad's custom LEMON patches

Crankshaft Position Sensor Replacement

Removal Procedure

1. Remove the exhaust manifold.
2. Disconnect the engine harness electrical connector from the crankshaft position (CKP) sensor.
3. Remove the CKP sensor stud (2).
4. Remove the CKP sensor (1).

Installation Procedure

1. Lubricate the CKP sensor O-ring with clean engine oil.
2. Install the CKP sensor (1).

Notice: Refer to Fastener Notice.

3. Install the CKP sensor stud (2).

Tighten the stud to 10 N.m (89 lb in).

4. Connect the engine harness electrical connector to the CKP sensor.
5. Install the exhaust manifold.