Replace and Program Control Module or Reprogram Control Module

To program a replacement or an existing control module, perform the following procedure:

1. Access the Service Programming System (SPS) and follow the on-screen instructions.
2. On the SPS Supported Controllers screen, select K17 Electronic Brake Control Module - Programming and follow the on-screen instructions.
3. On the SPS Supported Controllers screen, select K17 Electronic Brake Control Module - Configuration and Setup while following the on-screen instructions.
4. At the end of Configuration and Setup, cycle the ignition.
5. Choose the "Clear All DTCs" function on the SPS screen, cycle the ignition.
6. Perform the Electronic Park Brake Learn procedure.