Replace and Program Frontview Camera Module or Reprogram Frontview Camera Module (without UGN)
NOTE:
Due to continuous improvements, the on screen selections may vary from instructions below.
To program a replacement or an existing B174W Frontview Camera - Windshield, perform the following procedure:
- Ignition/Vehicle OFF
- Access the Service Programming System (SPS) and follow the on-screen instructions.
- On the SPS Supported Controllers screen, select B174W Frontview Camera - Windshield - Programming and follow the on-screen instructions.
- On the SPS Supported Controllers screen, select B174W Frontview Camera - Windshield - Setup (if this option is available) and follow the on-screen instructions.
- Clear DTCs.
- Following B174W Frontview Camera - Windshield replacement and reprogramming, the module must be calibrated. Refer to Front View Camera - Windshield Learn .