Verification Procedure VER-3: Notes

Download the full database via torrent (~1.1 TB) | Download Brad's custom LEMON patches

Inspect vehicle to ensure all engine components are connected. Reassemble and reconnect components as necessary. If another fault was read previously and not corrected, return to TEST DR-1A and follow path specified by other fault. If Single Board Engine Controller (SBEC) has been replaced, perform following:

If vehicle is equipped with factory theft alarm, start vehicle at least 20 times so alarm system may be activated when desired.
Connect DRB-II to engine diagnostic connector, and erase faults. Disconnect DRB-II.