Fuel System Pressure Release
WARNING:
Always release fuel pressure before disconnecting any fuel injection-related component. DO NOT allow fuel to contact engine or electrical components.
- Remove fuel pump relay. Fuel pump relay is located in power distribution center at driver's side front corner of engine compartment, just in front of strut tower.
- Start engine and allow engine to idle until engine stalls. Attempt to restart engine until engine will no longer run. Turn ignition off.
- Diagnostic Trouble Codes (DTC) may have been stored in Powertrain Control Module (PCM) due to the removal of fuel pump relay. Using scan tool, clear DTCs from PCM. See CLEARING DIAGNOSTIC TROUBLE CODES .