Sun Sensor: Installation
WARNING: This page is about a different car, the 2002 Dodge Intrepid, 2002 Chrysler Intrepid, 2002 Chrysler Concorde, and 2002 Chrysler 300M. However, it is still accessible from the selected car via links, so may be relevant.
- Connect the wiring harness connector to the sensor and position in the vehicle. Install the two sensor fasteners.
- Install the instrument panel top cover. See ANALOG INSTRUMENT PANELS - CONCORDE, INTREPID & 300M article. Connect the negative battery cable remote terminal to the remote battery post.
If the sensor does not protrude 1/4 inch, perform the following procedure:
- Confirm that the top cover is properly installed.
- Remove the top cover.
- Remove fasteners from sun sensor.
- Install one 1/4-20 nut per fastener under the sun sensor so that it is shimmed higher.
- Reinstall the sun sensor. Do not overtighten screw. If a longer screw is required, use 8-15x1 inch.