Ignition Cable: Service and Repair

Download the full database via torrent (~1.1 TB) | Download Brad's custom LEMON patches

Failure to route the cables properly could cause the radio to reproduce ignition noise, cross ignition of the spark plugs or short circuit the cables to ground.

REMOVAL
1. Remove spark plug cable from coil first.
2. Always remove the spark plug cable by grasping the top of the spark plug insulator, turning the boot 1/2 turn and pulling straight up in a steady motion.

INSTALLATION
1. Install spark plug insulators over spark plugs.
2. Ensure the top of the spark plug insulator covers the upper end of the spark plug tube.
3. Connect the cables to the spark plugs, the connect the other ends to the coil pack. Be sure that the dual plastic clip holds the cables off of the valve cover.