Sun Sensor: Installation
- Connect the wiring harness connector to the sensor and position in the vehicle. Install the two sensor fasteners.
- Install the instrument panel top cover. See ANALOG INSTRUMENT PANELS - CONCORDE, INTREPID & 300M article. Connect the negative battery cable remote terminal to the remote battery post.
If the sensor does not protrude 1/4 inch, perform the following procedure:
- Confirm that the top cover is properly installed.
- Remove the top cover.
- Remove fasteners from sun sensor.
- Install one 1/4-20 nut per fastener under the sun sensor so that it is shimmed higher.
- Reinstall the sun sensor. Do not overtighten screw. If a longer screw is required, use 8-15x1 inch.