Elapsed Time Inoperative Or Wrong
NOTE:
After making any repairs, perform BODY VERIFICATION TEST
under VERIFICATION TESTS.
Possible Causes:
- BCM - Elapsed Time Inoperative Or Wrong
Testing
- Clear current elapsed time from Overhead Travel Information System (OTIS). Start engine and monitor elapsed time on OTIS. If elapsed time is still malfunctioning, replace Body Control Module (BCM). If elapsed time is operating properly, fault may be intermittent. Check related wiring and connectors for poor connections or damage to wiring harness. See WIRING DIAGRAMS . Repair any problems found as necessary. If no problems are found, check if any Technical Service Bulletins (TSBs) apply to vehicle. If no TSBs apply, test is complete.