Brake Fluid: Service and Repair
STANDARD PROCEDURE - BRAKE FLUID LEVEL CHECKCheck master cylinder reservoir brake fluid level a minimum of twice a year.
Master Cylinder Fluid Level:
Master cylinder fluid reservoirs for both standard and antilock brake systems are marked with a FULL fill line indicating the reservoirs proper fluid level.
NOTE: When filling brake fluid reservoir, use only Mopar brake fluid or an equivalent stored in a tightly sealed container. Brake fluid must conform to DOT 3 specifications. Do not use brake fluid with a lower boiling point than DOT 3, as brake failure could result during prolonged hard braking. Do not use petroleum-based fluid because seal damage in the brake system will result.
If necessary, add brake fluid to reservoir, bringing brake fluid level to the FULL fill line shown on fluid reservoir.
The master cylinder brake fluid reservoir used on this vehicle includes a brake fluid level switch. The brake fluid level sensor location is in the body of the brake fluid reservoir. In the event of low brake fluid level in the brake fluid reservoir, the RED brake warning indicator lamp in the instrument cluster will turn on.