Brad's Car Manuals: A 3rd party mirror of CHARM + LEMON car manuals
Home >> Chrysler >> 2005 >> Pacifica Limited >> Repair and Diagnosis >> Engine Mechanical >> Fuel System >> Accelerator Pedal >> Installation

Accelerator Pedal: Installation

Download the full database via torrent (~1.1 TB)  |  Download Brad's custom LEMON patches
  1. Place accelerator pedal assembly over mounting studs protruding from floor pan. See Fig 1. Tighten retaining nuts to 12 N.m (105 in. lbs.) torque.
    Fig 1: Mounting Nuts
    GC0000443Courtesy of DAIMLERCHRYSLER CORP.
  2. Place cable through slot in top of pedal shaft. See Fig 2.
    Fig 2: Cable Attachment Exploded View
    GC0000445Courtesy of DAIMLERCHRYSLER CORP.
  3. While holding pedal lever. Push retainer clip forward in vehicle engaging it into the pedal lever. See Fig 3.
    Fig 3: Cable Attachment To Pedal
    GC0000444Courtesy of DAIMLERCHRYSLER CORP.
  4. Hold the throttle body lever in the wide open position and install the throttle cable. See Fig 4.
    Fig 4: Cable At Throttle Body
    GC0000446Courtesy of DAIMLERCHRYSLER CORP.
  5. Before starting engine, operate accelerator pedal to check for any binding.