Control Module: Testing and Inspection

Download the full database via torrent (~1.1 TB)

STANDARD PROCEDURE - TCM QUICK LEARN

The quick learn procedure requires the use of the scan tool.

This program allows the electronic transmission system to recalibrate itself. This will provide the proper transmission operation. The quick learn procedure should be performed if any of the following procedures are performed:

- Transmission Assembly Replacement
- Transmission Control Module Replacement
- Solenoid Pack Replacement
- Clutch Plate and/or Seal Replacement
- Valve Body Replacement or Recondition

To perform the Quick Learn Procedure, the following conditions must be met:

- The brakes must be applied
- The engine speed must be above 500 rpm
- The shift lever position must stay in Park until prompted to shift to Drive
- The shift lever position must stay in Drive after the Shift to Drive prompt until the scan tool indicates the procedure is complete
- The calculated oil temperature must be above 15.6°C (60°F) and below 93.3°C (200°F)