Test Equipment
The following equipment is recommended to diagnose and test the EEC system. Some equipment is REQUIRED to perform tests. DO NOT attempt to test this system without proper equipment. Damage to vehicle components may result if improper equipment is used.
- The Self-Test Automatic Read-Out (SUPER STAR II) diagnostic tester is recommended but not required. It is specially built for EEC systems and is used to display the 2-digit (numeric) service codes that are programmed into the control module. Aftermarket Scan tools are also available.
- Analog Volt/Ohmmeter (VOM) with 0-20V DC range. This can be used, as an alternative to a diagnostic tester, to read codes only.
- Digital Volt/Ohmmeter (DVOM) with minimum 10-megohm input impedance.
- Breakout Box. This is a jumper wire assembly that connects between the vehicle harness and the ECA. The breakout box is required to perform certain tests on the system. Ford Motor Co. specifically states that back-probing will cause PERMANENT DAMAGE to the ECA connector. The test pin No. called out in CIRCUIT TESTS refers to test pin numbers on breakout box. Once the breakout box has been installed during a test sequence, it may remain connected for the remainder of that test unless otherwise specified. Aftermarket breakout boxes are available.
- Vacuum gauge with 0-30 in. Hg range and resolution (units on scale) of 1 in. Hg.
- Tachometer with 0-6000 RPM range, accuracy +/- 40 RPM, and a resolution of 20 RPM.
- Vacuum pump with 0-30 in. Hg range.
- Timing light.
- Spark Tester (D81P-6666-A or ST-125). A modified side electrode spark plug IS NOT sufficient for these testing procedures.
- Fuel Injection Pressure Gauge (T80L-9974-A).
- 12-volt test light (non-powered type).
- Jumper wire, about 15" long.