ARW-5 Signal At Abs Control Unit

Download the full database via torrent (~1.1 TB) | Download Brad's custom LEMON patches

Ensure ignition is off. Set voltmeter to 5V AC scale. Measure voltage between ABS control unit terminal 2E (Yellow/Green wire) and terminal 2F (Yellow/Blue wire), and between ABS control unit terminal 2H (Green wire) and terminal 2J (Blue wire). Rotate rear wheels 60 RPM. Voltage should be greater than .25 volt AC. If voltage is correct, go to ARW-7 ABS CONTROL UNIT CHECK . If voltage is not correct, go to ARW-6 SENSOR SET-UP CHECK .