Camshaft Position Sensor: Service and Repair

Download the full database via torrent (~1.1 TB) | Download Brad's custom LEMON patches

CAMSHAFT POSITION (CMP) SENSOR

Removal and Installation

RH sensor
1. Remove the air cleaner outlet pipe.

LH sensor
2. Remove the air cleaner assembly.

Both sensors
3. Disconnect the camshaft position sensor (CMP) electrical connector.
4. Remove the bolt and the CMP sensor.
- To install, tighten to 10 Nm (89 lb-in).

5. NOTE: Lubricate the CMP O-ring seal with clean engine oil.

To install, reverse the removal procedure.