Crankshaft Position Sensor: Service and Repair

Download the full database via torrent (~1.1 TB) | Download Brad's custom LEMON patches

Crankshaft Position (CKP) Sensor

Removal and Installation

1. With the vehicle in NEUTRAL, position it on a hoist.

2. Remove the LH catalytic converter.

3. Remove the bolt, nut and the heat shield.
- To install, tighten to 10 Nm (89 lb-in).

4. Remove the rubber grommet cover.

5. Disconnect the Crankshaft Position (CKP) sensor electrical connector.

6. Remove the bolt and the CKP sensor.
- To install, tighten to 10 Nm (89 lb-in).

7. To install, reverse the removal procedure.