Control Module: Service and Repair

Download the full database via torrent (~1.1 TB) | Download Brad's custom LEMON patches

All Wheel Drive (AWD) Relay Module

Removal and Installation

1. If equipped, remove the RH floor storage compartment.
1. Lift the liftgate scuff plate upward, releasing the 4 retaining clips. For additional information, refer to Interior Trim - Exploded View in Trim Panel.

2. Remove the RH floor storage compartment.

2. Disconnect the All-Wheel Drive (AWD) relay module electrical connector.

3. Remove the AWD (All-Wheel Drive) relay module nut.
- To install, tighten to 7 Nm (62 lb-in).

4. To install, reverse the removal procedure.