Camshaft Position Sensor: Service and Repair

Download the full database via torrent (~1.1 TB) | Download Brad's custom LEMON patches

Camshaft Position (CMP) Sensor

Removal and Installation

1. Disconnect the Camshaft Position (CMP) sensor electrical connector.

2. Remove the bolt and the CMP (Camshaft Position) sensor.
- To install, tighten to 7 Nm (62 lb-in).

- Inspect the O-ring seal and install new as necessary.

3. NOTE: Lubricate the CMP (Camshaft Position) sensor O-ring seal with clean engine oil.
To install, reverse the removal procedure.