Oil Pressure Sensor: Service and Repair

Download the full database via torrent (~1.1 TB) | Download Brad's custom LEMON patches

Engine Oil Pressure (EOP) Switch

Removal and Installation

1. Disconnect the Engine Oil Pressure (EOP) switch electrical connector.

2. Remove the EOP (Engine Oil Pressure) switch.
- To install, tighten to 14 Nm (124 lb-in) then an additional 180 degrees.

3. To install, reverse the removal procedure.
- Apply thread sealant with PTFE to the EOP (Engine Oil Pressure) switch threads prior to installation.