Replace and Program Active Safety Control Module or Reprogram Active Safety Control Module
WARNING: This page is about a different car, the 2020 GMC Acadia. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
Due to continuous improvements, the on screen selections may vary from instructions below.
To program a replacement or an existing K124 Active Safety Control Module, perform the following procedure:
- Access the Service Programming System (SPS) and follow the on-screen instructions.
- On the SPS Supported Controllers screen, select K124 Active Safety Control Module - Programming and follow the on-screen instructions.
- Clear DTCs.