Brad's Car Manuals: A 3rd party mirror of CHARM + LEMON car manuals
Home >> Geo >> 1989 >> Tracker Base, Automatic >> Repair and Diagnosis >> Engine Performance >> System >> System/Component Tests >> Relays & Solenoids >> Relays >> Control Relay (Tracker)

Control Relay (Tracker)

Download the full database via torrent (~1.1 TB)  |  Download Brad's custom LEMON patches
  1. Disconnect relay connector. Using an ohmmeter, place positive test lead of ohmmeter on relay terminal "B" and negative test lead of ohmmeter on relay terminal "D". See Fig 1 . Ensure there is continuity.
  2. Place positive test lead of ohmmeter on relay terminal "D" and negative test lead of ohmmeter on relay terminal "B". If continuity is present, replace relay.
  3. Check continuity between terminals "I" and "F", and then between "J" and "H". If continuity is not present, replace relay.
  4. Energize solenoid by applying battery voltage to terminal "B" and ground to terminal "D". Check for voltage at terminals "C" and "E". If battery voltage does not exist, replace control relay.
  5. Energize solenoid by applying battery voltage to terminal "F" and ground to terminal "I". Check for voltage at terminal "G". If battery voltage does not exist, replace control relay.
  6. Energize solenoid by applying battery voltage to terminal "H" and ground to terminal "J". Check for voltage at terminal "G". If battery voltage does not exist, replace control relay.
Fig 1: Control Relay (Tracker)
G121712Courtesy of GENERAL MOTORS CORP.
scientia non olet · About Brad's Car Manuals