Vehicle Stability Control Module (VSCM) Replacement and Setup
WARNING: This page is about a different car, the 2010 Cadillac STS. However, it is still accessible from the selected car via links, so may be relevant.
The following service procedures require either a programming or a setup event performed for a complete repair.
If the vehicle stability control module (VSCM) is replaced, the following procedures must be performed in the following order:
- Revise the steering position sensor centering setup procedure using the Scan Tool module setup function.
- Revise the acceleration sensor reset procedure using the Scan Tool module setup function
- Revise the VSCM power steering reset procedure using the Scan Tool module setup function.