Brad's Car Manuals: A 3rd party mirror of CHARM + LEMON car manuals
Home >> Hummer >> 2009 >> H3 Alpha >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls And Fuel - 5.3L - Introduction >> Repair Instructions >> Accelerator Pedal Replacement >> Installation Procedure

Installation Procedure

Download the full database via torrent (~1.1 TB)  |  Download Brad's custom LEMON patches
    Fig 1: Remove/Install Accelerator Pedal Position APP Sensor
    GM1560065Courtesy of GENERAL MOTORS CORP.
  1. Install the accelerator pedal/APP sensor over the studs.
    2. CAUTION: Refer to Fastener Caution
  2. Install the accelerator pedal/APP sensor nuts and tighten to 9 N.m(80 lb in).
    3. Fig 2: View Of APP Sensor
    GM1352013Courtesy of GENERAL MOTORS CORP.
  3. Connect the body wiring harness electrical connector to the APP sensor.
  4. Inspect below the pedal for binding, to ensure full range of motion.
  5. Install the knee bolster bracket. Refer to Driver Knee Bolster Bracket Replacement (Right Hand Drive) or Driver Knee Bolster Bracket Replacement (Left Hand Drive) .
scientia non olet · About Brad's Car Manuals