Brad's Car Manuals: A 3rd party mirror of CHARM + LEMON car manuals
Home >> Hummer >> 2010 >> H3 Base, Automatic >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls And Fuel - 3.7L - Repair Instructions >> Repair Instructions >> Throttle Body Assembly Replacement >> Installation Procedure

Installation Procedure

Download the full database via torrent (~1.1 TB)  |  Download Brad's custom LEMON patches
    Fig 1: Throttle Body & Bolts
    GM742490Courtesy of GENERAL MOTORS CORP.
  1. Insert a new seal into the intake manifold groove.
  2. Position the throttle body (2) to the intake manifold.
  3. CAUTION: Refer to Fastener Caution .
  4. Install the throttle body bolts (1) and tighten to 10 N.m (89 lb in).
  5. Fig 2: Engine Wiring Harness Connections To Camshaft Cover & Throttle Body
    GM1350717Courtesy of GENERAL MOTORS CORP.
  6. Connect the throttle body electrical connector (2).
  7. Fig 3: EVAP Canister Purge Pipe, Throttle Body Module & EVAP Canister Purge Solenoid Valve
    GM1352026Courtesy of GENERAL MOTORS CORP.
  8. Connect the EVAP canister purge pipe (1) to the throttle control module (2). Refer to Plastic Collar Quick Connect Fitting Service .
  9. Install the air cleaner resonator and outlet duct. Refer to Air Cleaner Resonator and Outlet Duct Replacement .
  10. Perform the throttle learn procedure. Refer to Throttle/Idle Learn .