[In The Case Of Installing New ECM]
- Perform
"Key teaching" procedure with GDS. Refer to TEACHING PROCEDURES
(Refer to Body Electrical System - "IMMOBILIZER SYSTEM ")
CAUTION:
- When replacing the ECM, the vehicle equipped with the smart key system (Button start) must be performed procedure as below.
- Insert the key (or press the start button) and turn it to the IGN ON and OFF position. Then the ECM learns the smart key information automatically.
- Turn ignition switch OFF and disconnect the negative (-) battery cable
- Remove the battery.
(Refer to Engine Electrical System - "BATTERY ")
- Disconnect the ECM Connector (A)
- Remove the mounting bolts & nut (B) and then remove the ECM bracket assembly (C).
- Remove the mounting nuts (A), and then remove the ECM (B) from the ECM bracket assembly.