Idle Air Volume Learning: Preparation

Before performing Idle Air Volume Learning, make sure that all of the following conditions are satisfied.

Learning will be cancelled if any of the following conditions are missed for even a moment.

• Battery voltage: More than 12.9V (At idle)
• Engine coolant temperature: 70 - 99° C (158 - 210° F)
• PNP switch: ON
• Electric load switch: OFF

  (Air conditioner, headlamp, rear window defogger)

  On vehicles equipped with daytime light systems, if the parking brake is applied before the engine is started, the headlamp will not be illuminated. 

• Steering wheel: Neutral (Straight-ahead position)
• Vehicle speed: Stopped
• Transmission: Warmed-up

  For models with CONSULT-II, drive vehicle until FLUID TEMP SE in DATA MONITOR mode of A/T system indicates less than 0.9V.

  For models without CONSULT-II, drive vehicle for 10 minutes.