6. Check Fuel Level Sensor Input Signal Circuit For Open And Short

1. Disconnect ECM harness connector.
2. Check harness continuity between the following;

   ECM terminal 119 and "fuel level sensor unit and fuel pump" terminal 5,

   ECM terminal 107 and "fuel level sensor unit and fuel pump" terminal 6.

   Refer to WIRING DIAGRAM .

   Continuity should exist. 

3. Also check harness for short to ground and short to power.

OK or NG 

1. OK: GO TO 8. CHECK FUEL LEVEL SENSOR .
2. NG: GO TO 7.