7. Check FPCM Input Signal Circuit For Open And Short

1. Disconnect ECM harness connector.
2. Check harness continuity between ECM terminal 116 and FPCM terminal 4. Refer to WIRING DIAGRAM .

   Continuity should exist. 

3. Check harness continuity between ECM terminal 116 and ground. Refer to WIRING DIAGRAM .

   Continuity should not exist. 

4. Also check harness for short to power.

OK or NG 

1. OK: GO TO 9. CHECK FPCM OUTPUT SIGNAL CIRCUIT FOR OPEN AND SHORT .
2. NG: GO TO 8.