1. Check Remote Keyless Entry Receiver Power Supply Circuit

1. Remove electronic key from ignition key cylinder.
2. Disconnect remote keyless entry receiver connector.
3. Check the signal between remote keyless entry receiver connector B246 terminal 4 (L) and ground with oscilloscope.

Fig 1: Checking Remote Keyless Entry Receiver Power Supply Circuit (1 Of 2)

Courtesy of NISSAN MOTOR CO., U.S.A.

Fig 2: Checking Remote Keyless Entry Receiver Power Supply Circuit (2 Of 2)

Courtesy of NISSAN MOTOR CO., U.S.A.

OK or NG 

1. OK: GO TO 2.
2. NG: GO TO 5.