Diagnostic Trouble Codes Confirmation Procedure: Notes
NOTE:
- If DTC Confirmation Procedure has been previously conducted, always turn ignition switch OFF and wait at least 10 seconds before conducting the next test.
- If the target idle speed is out of the specified value, perform "IDLE AIR VOLUME LEARNING ", before conducting DTC Confirmation Procedure. For the target idle speed, refer to "SERVICE DATA AND SPECIFICATIONS (SDS) ".
TESTING CONDITION:
- Before performing the following procedure, confirm that battery voltage is more than 11V at idle.
- Always perform the test at a temperature above - 10°C (14°F).