Control Device Removal and Installation: Installation

Note the following, and install in the reverse order of removal.

After installation is completed, adjust and check A/T position. Refer to "ADJUSTMENT OF A/T POSITION " and "CHECKING OF A/T POSITION ".

Note the following, and install in the reverse order of removal.

NOTE: Bend control device assembly (1) to vehicle, then insert lower lever (2) to the rear of vehicle.

After installation is completed, adjust and check A/T position. Refer to "ADJUSTMENT OF A/T POSITION " and "CHECKING OF A/T POSITION ".

Fig 1: Inserting Lower Lever To Rear Of Vehicle
Courtesy of NISSAN MOTOR CO., U.S.A.