Component Function Check

WITH CONSULT

1. Start engine.
2. Check "MAP SENSOR" in "DATA MONITOR" mode with CONSULT.

   Monitor Item	Condition		Values/Status
   MAP SENSOR	Engine: After warming up Selector lever: P or N position A/C switch: OFF No load	Idle	Approx. 1.0 V
   		2, 000 rpm	Approx. 1.35 V

WITHOUT CONSULT

1. Start engine.
2. Check the voltage between ECM harness connector and ground.

   ECM				Condition	Voltage
   +		-
   Connector	Terminal	Connector	Terminal
   F110	67	E80	175	[Engine is running] Warm-up condition Idle speed	1.2 V
   				[Engine is running] Warm-up condition Engine speed: 2, 000 rpm	1.5 V

   Is the inspection result normal? 

   YES: INSPECTION END

   NO: Proceed to "DIAGNOSIS PROCEDURE ".