Ignition Battery Saver System
When all the following conditions are met for 10 minutes, the ignition battery saver system will cut off the power supply (ignition switch ON => OFF) to prevent battery discharge.
- Ignition switch ON
- Turn signal lamp is not in operation
- Selector lever is in the P (park) position
NOTE:
For 1 minute after 10 minutes have passed or 3 minutes after 7 minutes are passed, the following display is indicated on information display in combination meter and sounds buzzer in combination meter.
|
Combination meter |
Time |
|
|
Information display |
Buzzer |
|
|
Power turned off to save the battery |
two seconds |
For 1 minute after 10 minutes have passed |
|
Power will turn off to save the battery |
3 minutes after 7 minutes are passed |
|
Reset Condition of Ignition Battery Saver System
If any of the following conditions are met the battery saver system is released.
- Ignition switch OFF
- Turn signal lamp is in operation.
- Selector lever is not in the P position.
NOTE:
The ignition battery saver system can be temporarily disabled, without using CONSULT, to prevent it from functioning when performing trouble diagnosis. Refer to Work Procedure .