Brad's Car Manuals: A 3rd party mirror of CHARM + LEMON car manuals
Home >> Isuzu >> 1983 >> Impulse Automatic >> Repair and Diagnosis (Single Page) >> Engine Performance >> System >> Fuel Injection System - I-TEC EFI >> Component Testing >> O2 Sensor

O2 Sensor

Download the full database via torrent (~1.1 TB)  |  Download Brad's custom LEMON patches
  1. The O2 sensor can not be tested directly but its control signal can be checked. A circuit tester having an internal resistance of approximately 20,000 ohms is necessary to test the circuit.
  2. Unplug the O2 sensor harness at connector. Insert a fine wire into the vehicle side connector and attach circuit tester. Set tester scale to 2V.
  3. Start engine and check voltage when engine speed is momentarily increased. Tester needle should deflect from 0 to 8V.
scientia non olet · About Brad's Car Manuals