Throttle Position Sensor: Service and Repair

Download the full database via torrent (~1.1 TB) | Download Brad's custom LEMON patches

Throttle Position Sensor
REMOVAL

1. Disconnect the negative battery cable.
2. Disconnect the TPS electrical connector.
3. Remove the two screws and TP sensor from the throttle body.

NOTE: Do not clean the TP sensor by soaking it in solvent. The sensor will be damaged as a result.

INSTALLATION

1. Install the TP sensor on the throttle body with two screws.
2. Connect the electrical connector.

3. Connect the negative battery cable.