Blower Motor Control Processor

Download the full database via torrent (~1.1 TB) | Download Brad's custom LEMON patches

BLOWER MOTOR CONTROL PROCESSOR REPLACEMENT

REMOVAL PROCEDURE
1. Remove the right closeout panel.
2. Disconnect the electrical connector from the blower motor.

3. Disconnect the electrical connector (3) from the blower motor control processor (1).
4. Remove the blower motor control processor mounting screws (2).
5. Remove the blower motor control processor (1).

INSTALLATION PROCEDURE

1. Install the blower motor control processor (1).
2. Install the blower motor control processor mounting screws (2).

Tighten the screws to 1.9 N.m (17 lb in).

NOTE: Refer to Fastener Notice in Service Precautions.

3. Connect the electrical connector (3) to the blower motor control processor (1).
4. Connect the electrical connector to the blower motor.
5. Install the right closeout panel.