Brad's Car Manuals: A 3rd party mirror of CHARM + LEMON car manuals
Home >> Jaguar >> 1992 >> XJS 2D Convertible >> Repair and Diagnosis >> Engine Performance >> Remove, Overhaul & Install >> Engine Controls - Remove/Install/Overhaul >> Ignition System >> Distributor (XJS) >> Removal

Distributor (XJS): Removal

Download the full database via torrent (~1.1 TB)  |  Download Brad's custom LEMON patches
  1. Disconnect negative battery cable. Raise and support vehicle. Remove crankshaft sensor (flywheel sensor) heat shield. Remove flywheel sensor. Rotate flywheel until No. 1 piston is at TDC. Ensure crankshaft timing marks are aligned.
  2. Install flywheel sensor and heat shield. Lower vehicle. Disconnect front and rear coil connectors. Remove bolts from cruise control bellow support bracket. Disconnect wiring harness connector and vacuum hose from cruise control assembly.
  3. Lift cruise control assembly and position aside. Remove distributor cap. Ensure distributor rotor is aligned with TDC mark on distributor housing. See Figure . Remove distributor retaining bolts and distributor.
scientia non olet · About Brad's Car Manuals