Oil Temperature Sensor For ECM: Service and Repair

Download the full database via torrent (~1.1 TB) | Download Brad's custom LEMON patches

Inspection

1. Turn the ignition switch OFF.
2. Disconnect the OTS connector.
3. Remove the OTS.
4. After immersing the thermistor of the sensor into engine coolant, measure resistance between the OTS terminals 1 and 2.
5. Check that the resistance is within the specification.

Specification:Refer to "Specification"

Removal

1. Turn the ignition switch OFF.
2. Disconnect the OTS connector (A).
3. Remove the OTS.

Installation

1. Installation is reverse of removal.