ECM Neutral Mode Procedure

Download the full database via torrent (~1.1 TB)

After replacing the ECM of the vehicle with the immobilizer, the following procedure must be performed.
[If installing a used ECM]

Perform "ECM Neutral Mode" procedure using GDS. (Refer to "Body Electrical System - "SMART KEY SYSTEM - Repair Procedures"")
After finishing "ECM Neutral Mode", perform "Key Teaching" procedure using GDS. (Refer to "Body Electrical System - "SMART KEY SYSTEM - Repair Procedures"")
[If installing a new ECM]

Perform "Key Teaching" procedure using GDS. (Refer to "Body Electrical System - "SMART KEY SYSTEM - Repair Procedures"")

After replacing the ECM of the vehicle with the smart key system (button start), the following procedure must be performed.
[If installing a used ECM]

Perform "ECM Neutral Mode" procedure using GDS. (Refer to "Body Electrical System - "SMART KEY SYSTEM - Repair Procedures"")
After finishing "ECM Neutral Mode", turn IGN ON then OFF using the smart key or start button. Then the ECM learns information on the smart key automatically.
[If installing a new ECM]

Turn IGN ON then OFF using the smart key or start button. Then the ECM learns information on the Smart Key automatically.