ECM Neutral Mode Procedure (With Immobilizer)
- After replacing the ECM of the vehicle with the immobilizer, the following procedure must be performed.
[If Installing a Used ECM]
- Perform
"ECM Neutral Mode" procedure using KDS.
(Refer to REPAIR PROCEDURES Body Electrical System - "Immobilizer System")
- After finishing "ECM Neutral Mode", perform
"Key Teaching" procedure using KDS.
(Refer to REPAIR PROCEDURES Body Electrical System - "Immobilizer System")
[If Installing A New ECM]
Perform "Key Teaching" procedure using KDS.
(Refer to REPAIR PROCEDURES Body Electrical System - "Immobilizer System")
- Perform
"ECM Neutral Mode" procedure using KDS.