Manual Shifting Test

HINT:

• With this test, it can be determined whether trouble occurs in the electrical circuit. Also, trouble can be a mechanical problem in the transaxle.
• If any abnormalities are found in the following test, the problem is in the transaxle itself.

1. Disconnect the TCM connector.
2. Drive the vehicle with the TCM disconnected. Shifting the shift lever to the D position to check whether the shifting condition changes as shown in the table below.
   SHIFT POSITION
   
   

   Shift Position	Shifting Condition
   D	No Shift (No Change)

   HINT:

   When driving the vehicle with the TCM disconnected, the gear position will be as follows:

   • When the shift lever is in the D position, the transmission will stay in 3rd gear.
   • When the shift lever is in the R or P position, the transmission will also be in the R or P position respectively.
     Fig 1: Disconnecting TCM Connector

     Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
3. Connect the connector of the TCM.
4. Clear the DTC (See DTC CHECK / CLEAR  ).